AMT Datasouth Fastmark M1 Betriebsanweisung PDF herunterladen (Seite 498)

Supported Printers and Drivers

Zebra Label Specific RFID Options

Use Label or Printer

Options

This allows you to use either your settings in the Label Specific Options or those set in the

Printer Specific Options.

Set Up Options Section

Send Setup Options to

Printer

When checked, the setup options selected on this dialog

are used for printing.

Tag Type

Auto-detect automatically determines the tag type by

querying the tag. Select “None” if no tags are available. If

the printer supports it, select from: EPC Class 0, EPC Class

0 Plus, EPC Class 1 64-bit, EPC Class 1 96-bit, ISO 18000-

06B, EPC Gen2, Philips HF I-Code, Philips HF I-Code ISO

15693, TI HF Tag-it, or TI HF Tag-it ISO 15693. (Note that

not all tag types are supported by all printers. Refer to the

RFID Devices and Tag Types section.)

Transponder Position

From Top of Label

The position in Dot Rows from the top of the label to the

RFID Transponder embedded in the label. The default

position is 8 Dot Rows from the top of the label. '0' dot

rows means that the Transponder is not to be moved from

its default position.

Length of Void Printout

This lets you determine how much of the label is printed

with a "VOID" warning when the encoding or reading of

the RFID tag fails. The default of "0" prints the VOID

message the entire length of the label.

Number of Labels to Retry

in Case of Read/Encode

Failure

This setting allows you to determine how many retries are

allowed after a failure while encoding the RFID tag or

label. As the cost of RFID smart labels and tags is still fairly

high, setting this to a low number may be advisable.

Write Options Section

Number of Times to Retry

This setting determines the number of times to retry

writing to the tag in case of initial failure. The default

setting is 0.

Feed Label After Writing

When checked, the label is fed from the printer for

removal and use after writing.

Enable RFID Motion

By default, labels automatically print at the end of the

format. When deselected, the label is not moved when it

reaches the program position. Note that this setting must

be specified for each label; it is not automatically carried

over from one label to the next.

Write Protect

When checked, the data written to the tag is protected

and the tag may not be written to again. This could be

used for example, as a pre-emptive step to prevent a label

in transit from being altered, thus rendering the original

encoding to the tag invalid.

Loftware Label Manager Version 10.1.1 User's Guide

498

1 2 ... 493 494 495 496 497 498 499 500 501 502 503 ... 531 532

Kommentare zu diesen Handbüchern

Keine Kommentare

AMT Datasouth Fastmark M1 Betriebsanweisung Seite 498

Kommentare zu diesen Handbüchern