AMT Datasouth Fastmark M1 Betriebsanweisung PDF herunterladen (Seite 429)

Intermec and UBI Printers

Label Handling Section

Applicat

A specialty device that is integrated with the printer that allows labels to be picked up from the printer

and placed on a product. Typical for assembly line production.

Self-

Strip

Self-strip handling requires that the stock in the printer be properly fed through the self-strip attachment

on the printer. Consult your Intermec manual or service technician for further assistance. While in self-

strip mode, the printer presents each label and waits for it to be removed before continuing. The printer

does not print labels if there is a label at the strip pin.

Cut Options Section

Cut or

Label

Cutter

These options require that a cutter be installed on the printer. With some Intermec printers, specifically

the Intermec 4400, you may have to set certain options on the printer.

Cut Every Allows the cutter to skip a given quantity of labels before cutting.

Forms Control Section

Settings are in dots.Use the dots per inch (dpi) for your printer to find the proper value. For example, if your

printer has 203 dpi and you want to set a skip distance of 1 inch, specify a value of 203 for the skip distance.

Top of Form

This setting determines how close to the leading edge of the label printing occurs. Valid values

are -20 to 4000, with 20 as the default setting. If you need to move the printing closer to

leading edge of the printer, lower the value. If you need to move the printing away from the

leading edge of the printer, choose a higher value. This setting is usually only critical when

you are using small labels.

Max Label Length

Maximum label length increases the allowed printing length of the label. Valid values are 200

to 4800 dots. For example, a 203 dpi printer allows you to set a value from .5" to 24". Setting

maximum label length to 2400 allows you to print a 12" label on an advanced Intermec

printer. The default for maximum label length is 1000 dots.

Image Bands

The Image band setting is used by the printer to decide how much of the label's format to

"image" before starting to print.If the image bands are set correctly, they can greatly improve

printer throughput. However, if they are set incorrectly, they can degrade performance.The

number of image bands available is determined by the amount of memory installed in your

printer. Consult your printer manual for the available range of image bands.If this parameter is

set to 0, the LLM uses the current printer setting.

Retract Distance

If this value is a non-zero value (try 1 or 2), the label is ejected this many “dots” after

printing.The printer retracts, or backfeeds, before printing the next label. This is useful for

advancing labels to the tear bar or cutter.Depending on your version of printer firmware, the

label may only advance/retract a set amount when you are using die cut or mark stock,

regardless of the value specified in the Retract parameter.Consult Intermec for information on

possible firmware upgrades.

Note: If you are using die cut stock or mark stock and have a 3400 or 4100 printer, you

must also check the “Feed After Print” option to enable the retract feature.

Skip Distance

(Continuous

Stock Only)

This setting is the distance to advance the label after all the fields have been printed.This

setting is used to create white space between labels.

Loftware LabelManager Version 10.1.1 User's Guide

429

1 2 ... 424 425 426 427 428 429 430 431 432 433 434 ... 531 532

Kommentare zu diesen Handbüchern

Keine Kommentare

AMT Datasouth Fastmark M1 Betriebsanweisung Seite 429

Kommentare zu diesen Handbüchern