AMT Datasouth Fastmark M1 Betriebsanweisung PDF herunterladen (Seite 380)

Barcode Symbology

If the Loftware Print Server is Configured to use Windows Registry Settings

If your Loftware Print Server is configured to use settings in the windows registry you must perform the

following additional steps to enable

[NativeOverride]

of QR Code printing to certain Zebra printers.

1. Select Start |All Programs | Loftware Labeling | Print Server | LPS Configuration. The Loftware

Print Server Configuration Utility opens.

2. Press Shift | F2. The Advanced tab appears. Select the Advanced tab.

3. Clear the Remap Ini Files to Registry checkbox, and click OK.

4. Add the [NativeOverride] setting to the LLMWDN32 configuration file as described in Enable

Native QR Code Printing in LLMWDN32.ini.

5. Repeat steps 1 and 2, and then reselect the Remap Ini Files to Registry checkbox. Click OK.

Building QR Code Barcodes

QR Code is a high capacity, two-dimensional square matrix symbology that is made up of a pattern of

dark and light square modules, packing information in two directions.It supports encoding modes for

numeric, alphanumeric, 8-bit byte, and Kanji data.Depending on the data encoding mode, a QR Code

symbol can include up to 6743 characters.

There are 39 QR Code symbol versions ranging from 21 x 21 (Version 1) to 173 x 173 (Version 39)

modules per side. Each higher version increases by 4 modules per side.

In LLM, you can use a Keyboard or a Formula data source for the QR Code data. You can pass the data

using a .pas, a .csv. or an .xml file.

1. For the barcode symbology, select QR Code.

2. Default Cell Width depends on the printer dpi capability.The options are 1 to 52 pixels.

3. Select a Data Input Mode:

l Auto - With Automatic data input, data with any character greater than character value 126 is

assumed to be Kanji data and automatically converted to Shift JIS before it is sent to the

printer.

l Manual mode - With one of the Manual data input options selected, you can control character

mode switching (Numeric, Alphanumeric, Binary, Kanji).You can use a formula with the

necessary ZPL data commands embedded. Kanji data must be passed as Shift JIS. For

information on ZPL programming, refer to the Zebra ZPL II Programming Guide.

4. Select an Error Correction level. Error Correction is used to restore data and improve reading if

the code is partially damaged. There are four levels of Error Correction.

5. Select a Mask pattern.This is used to balance the light and dark modules and minimize patterns

that may interfere with processing.Auto Selection applies the most appropriate masking pattern.

6. Select a Model number.Model refers to the QR Code specification.Model 1 is the original

Loftware Label Manager Version 10.1.1 User's Guide

380

1 2 ... 375 376 377 378 379 380 381 382 383 384 385 ... 531 532

Keine Kommentare

AMT Datasouth Fastmark M1 Betriebsanweisung Seite 380