AMT Datasouth Fastmark M1 Betriebsanweisung PDF herunterladen (Seite 457)

100

101

PCL5 Information

PCL5 Options

PCL5 Label Specific Options

PCL5 Page Size options include: A3, A4, A5, B4(JIS), B5(JIS), Com-10 Envelope, Custom, Executive,

Hagaki Postcard, International B5 Envelope, International C5 Envelope, International DL Envelope,

Ledger, Legal, Letter, Monarch Envelope, and Oufuku-Hagaki Postcard.Options supported by different

PCL5 printer models may vary.

The Custom page size option allows printing on custom paper size page stock to a PCL 5 Printer that

supports the custom size.

l A label can be designed with specified dimensions and then printed on a target PCL 5 printer that

supports the custom size and has been set up with the custom-sized paper. (These configuration

settings are made from the printer’s configuration interface (Control Panel).) The label dimensions

should correspond to the custom paper size.

l A label can also be configured with a page layout of specified label / page width and height, and

then printed on a target PCL 5 printer that supports the custom size and has been set up with the

custom-sized paper. The layout dimensions should correspond to the custom paper size.

Paper Source

Because of the variety of PCL5 supported page sizes, this setting allows you to configure the paper

source (tray) at the label level.By default, the Paper Source is set to the selection in the printer's PSO (Use

Printer Setup), but you can select any of the other options described in the PCL5 Printer Specific Options

section below.If a different option is selected and saved in the label format, then that option is used

whenever that label is printed, UNLESS a job containing a *TRAY command is submitted through

LPS.The *TRAY command overrides both the printer setting and the label setting.

Note: Different manufacturer’s printers may implement the handling of the Paper Source selection differently.

For example, one manufacturer may map the Lower Tray command to the printer's Lower Tray while another

manufacturer may map the same command to its Optional Tray. Additionally, these mappings may be

configurable, again depending upon the manufacturer.

Loftware LabelManager Version 10.1.1 User's Guide

457

1 2 ... 452 453 454 455 456 457 458 459 460 461 462 ... 531 532

Kommentare zu diesen Handbüchern

Keine Kommentare

AMT Datasouth Fastmark M1 Betriebsanweisung Seite 457

Kommentare zu diesen Handbüchern