AMT Datasouth Accel-7450 Bedienungsanleitung PDF herunterladen (Seite 13)

ACCEL-7450

HA Gap Adjust Label

Refer to the HA AJUST label located inside the printer behind the printhead carrier.

The numbers shown on the label represent the HA Print Gap settings made prior to

shipment. Restore the settings shown on the label using the HA PRINT GAP

procedures on pages 6~9. The following example shows how to read the table.

NOTE: If a minus sign is shown in the first-digit line of “MUL,” the setting is a negative

number.

EXAMPLE: Down = 16

UP = 45

Multiple = 1

 DW

This is the DOWN PULSE setting. It sets the distance by which the head travels

downward in the auto gap mode.

 UP

This is the UP PULSE setting. It sets the distance (print gap) by which the head

travels backward in the auto gap mode.

 MUL (HA MULTIPART ADJUST)

This is the HA MULTIPART ADJUST setting.

It sets the print density for copy paper. The HA MULTIPART ADJUST setting

adjustment is enabled only in the HA auto mode.

The HA MULTIPART ADJUST setting is adjustable between -15 and +15.

As the setting decreases, the print darkness increases.

HA ADJUST

MUL

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Keine Kommentare

AMT Datasouth Accel-7450 Bedienungsanleitung Seite 13